Chimney flashing repair in Atlanta, GA
Leaky chimney flashing resealed or replaced so the joint between your chimney and roof stays watertight.
Flashing is the metal that seals the joint where your chimney passes through the roof. It is one of the most common sources of chimney leaks, because roofs and chimneys move differently and sealant dries out and cracks over time.
Signs of failing flashing
Water stains on the ceiling or wall beside the chimney, damp in the attic around the chimney, rusted or lifting metal, or gaps and cracked sealant where the flashing meets the brick.
Repair or replace
If the flashing is sound but the seal has failed, we reseal it properly. If it is rusted, loose or was badly installed, we replace it with step and counter flashing set into the mortar joints, so water cannot get behind it.
Finding the real source
Not every leak beside a chimney is the flashing. We check the crown, cap and brick too, so we fix the actual cause.
Why choose us for this job
Flashing repairs are quoted in writing after we have found the source of the leak.
Call (678) 923-3593Common questions
Something else on your mind? Call (678) 923-3593 and ask.
How do I know if my chimney flashing is leaking?
Water stains near the chimney on the ceiling or walls, damp in the attic around it, or visible gaps and rust in the flashing are common signs.
Can flashing be repaired, or does it need replacing?
If the metal is sound, resealing may be enough. Rusted, loose or badly installed flashing should be replaced.
Is it the flashing or something else?
Leaks beside a chimney can also come from the crown, a missing cap or porous brick. Because we look at the whole chimney, we can tell you which it is before any work starts.
Available across Atlanta and the north metro
We provide this service in every area we cover. Choose yours to see the neighborhoods we work in.
Ready to book?
Call us or send a booking request. Open Monday to Friday, 9:00 AM to 6:00 PM.